Lost Data pad

[Arcade-Projects]

so per the fixing guide, here's what I've got.
A friend got a bit too hot working on the writing wires for the multi, lost a pad.
imgur.com/jfTZCPs

I've fixed up the rest, but I'm not sure where I can backtrace the lost pad.
Looking at the diagram in the main thread, I think I should be fine if I go back to the far side of the nearby resistor.
That is to say, not C117, but the surface mount component on the left in the picture.
Alternatively, I could also join to the corner pin directly behind the same component, yes?
What exactly I'm talking about is highlighted in Yellow-
imgur.com/a/GQVx43h

More...