Both pictures show the same thing but I didn’t know which one was more detailed. As the title states I want to know if there is anything that can be done to fix this poor psp. I tried to do an IPS screen mod but I used a very bad soldering iron and did it after taking my inhaler(it’s steroid and can make you shake). I got some solder on the ribbon cable connector removed it with the help of flux and wick, but now it won’t turn on. The green light turns on and off and nothing happens I’ve tried with the old screen too but to no avail. Is there anything I could do that might salvage this?(yea the right side of the connector was burnt when I got a few smaller soldering iron tips which required a higher temperature to melt solder due to low mass at the tip.) submitted by /u/imaweasle909 [link] [comments] |
More...