Will these terminals work on pi pico?

[/RaspberryPi]

So im a noobie in pi, i was thinking of using pi pico as a arcade pcb, i can solder pins on pico but after that i have to use crimps to connect the wires to the pico as i have wires soldered to my buttons and stick. So ive been searching alot about easier solution i came across this ""https://www.electronicscomp.com/10-pin-2.54mm-pitch-pluggable-screw-terminal-block?gclid=EAIaIQobChMI9fvZ387i-AIVB5hmAh387Q0GEAQYASABEgJeu_D_BwE"" the spacing for pin matches but i think soldering from front will interfere with some components so may solder from back . dimensions give on website are 26x6x12 So with 2 of the screw terminal on one side Lenght will be 52 Will they fit and work? Does anyone have any experience using them? I cant find anything online of someone using these terminal directly on pico. Thanks in advance.

submitted by /u/jewishpacifier
[link] [comments]

More...