Having trouble connecting 2 relay module to rpi4 in order to power pump

[/RaspberryPi]

I have been searching all over the internet for an honest solution but so far I have found none. I am a complete beginner when it comes to electronics and I would like to know how to power my small 3-6v pump I have for this plant watering build I am doing. As far as I can tell I need an independent power source which is used for the pump, a relay, breadboard and jumper cables. I have all of these things ready to go its just wiring is a headache and I don't want to get anything wrong or break anything. For the record I have a 5v battery pack I stripped from a light display.
I am certain I have the pi connected to the relay properly its just the rest I am not sure of. Here is a link to a diagram of what I have so far. Thanks!

submitted by /u/Less_Rhubarb_9020
[link] [comments]

More...